Mod Podge Image Transfers

This was a really easy project that only costs a few bucks. 
(Sorry there is only one picture)
Step 1: Find a piece of wood that is a desired size.

Step 2: Paint or stain the wood whatever colors you would like. Let dry

Step 3: Create a document on the computer of anything, and format it to fit the piece of wood you have chosen. 

Step 4: Mirror the image, so that you see everything backwards. 

Step 5: Print out the image, and cut paper to exact size of wood.

Step 6: Put a thin layer of Mod Podge all over the ink side of the paper and quickly put the Mod Podge side of the paper down on the painted side of the wood.   You should now have the paint side of the wood, and the ink side of the paper toughing. 
Step 7: Using a flat edge, smooth any bumps or small bubbles out of the paper so that it is completely smooth. Let dry for at least an hour.

Step 8: wet the entire board so that you can see the ink through the paper. Gently rub your finger on the paper to start removing it. Do not rub too hard, because you will rip the entire image. Slowly remove the paper until you have the final image you like. You should now be able to see your image printed onto the wood as shown above. 

Step 9: Put a layer of Mod Podge on top to make a top coat, and let dry. You can add another layer when that is dry if you would like. 

Step 10: ENJOY!